![usb loader gx forwarder wad m usb loader gx forwarder wad m](https://i.ytimg.com/vi/84ZjRYgueAA/hqdefault.jpg)
- #Usb loader gx forwarder wad m install#
- #Usb loader gx forwarder wad m update#
- #Usb loader gx forwarder wad m full#
There's no need to extract the dol from the channel, they are available here : Īlways the latest official stable release : Forwarder 5.1 for wii : Forwarder 5.
#Usb loader gx forwarder wad m full#
It's useful to kep the AHB access (unlocking the full GUI and banner layout mode) if you set "loader's IOS" setting to 58 because your HDD is not initiated correctly with slot 249.
#Usb loader gx forwarder wad m install#
If you want to autoboot into the loader from priiloader, instead of installing the forwarder.dol (it works, but only with cIOS), it's better to install the UNEO booter dol (which will launch the forwarder instead of the boot.dol) and works fine with IOS58 too. NOTE: turn off any proxy servers before proceedingĪrchive of the above page.You can find the forwarder channels here : Next choose "Network installation" as the installation more. Select "IOS38 v3867" as the Base IOS version. Press "A" again to accept the disclaimer. Use the Left and Right buttons on the D-PAD to select "IOS 36" and press "A". Now exit DOP-Mii and run the installer for either IOS 222 and/or 249 If either IOS 222 or 249 are marked (STUB) then uninstall them by pressing the minus (-) key on the Wiimote. Make sure IOS 222 and 249 are not marked (STUB) in the "Currently Installed" section (you can ignore the "Selected Version Details" section) Press the left arrow on the D-Pad and cycle through the IOS's. Which IOS would you like ot use to install other IOSes?
![usb loader gx forwarder wad m usb loader gx forwarder wad m](https://i.ytimg.com/vi/UeNzxrBIts0/maxresdefault.jpg)
Load the We_Hack_Wii package to an SD Card
#Usb loader gx forwarder wad m update#
Restoring USBLoader GC after accidental Update (SuperMario Galaxy 2) Make sure all files are installed correctly.Īfter that, your USB Loader should be working! Sometimes you will get one that is password protected though, if so just enter ab121b as the password and you will be fine. Like before, press A and choose network installation. Once you are there again choose to load cIOS36rev10 installer.